primary winding

英 [ˈpraɪməri ˈwɪndɪŋ]

美 [ˈpraɪmeri ˈwɪndɪŋ]

一次绕组；原绕组

电力

英英释义

noun

• coil forming the part of an electrical circuit such that changing current in it induces a current in a neighboring circuit
  1. current through the primary coil induces current in the secondary coil
  Synonym:primary coilprimary

双语例句

• Rising Current Method at CT Primary Winding and Its Application
  电流互感器一次升流的方法与应用
• With consideration of ST's insulation and volume, the parameter of ST was determined by the theory analysis and computation of the primary winding.
  通过对初级绕组的计算分析及考虑体积、绝缘的基础上，确定了ST的相关参数。
• Calculation of Dynamic Stability of Current Transformer with U Primary Winding
  U形一次绕组电流互感器的动稳定计算
• It is found that the magnetizing inrush current could be influenced significantly by following factors; excitation characteristic, resistance in the primary winding of TV, line-earth capacitance and its symmetry as well as damping resistance of the network.
  研究发现：TV的励磁特性和高压绕组直流电阻、系统三相对地电容及其对称性以及系统的阻尼率均对TV励磁涌流有明显影响。
• The High Tension ( HT) voltage is produced by mutual induction between the primary winding and the secondary winding, and the central soft iron core intensifies the magnetic field between them.
  通过初级绕组和次级绕组之间的互感产生出一个高电压，把两绕组联系起来的中心软体起导磁的作用，它把磁场集中起来。
• This paper introduces the importance of rising current at CT Primary Winding to the relay circuit check. And the method of rising current at CT primary winding and its application for switch and transformer bushing CTs in all kinds of operating modes are presented.
  讲述了电流互感器一次升流在继电保护回路验收中的重要性，并介绍了各种运行方式下开关CT与变压器套管CT一次升流的应用方法。
• The strength calculation method and the structure of current transformer with U primary winding to fulfil the dynamic stability requirements are introduced, and some calculating examples are given.
  介绍了U形一次绕组电流互感器可满足动稳定要求的结构及强度计算方法，并给出了计算实例。
• Considering the conditions as voltage at primary winding, shortcircuit forces of windings and turns for transformer were calculated with FEM coupling circuit method under the 2D symmetrical model.
  以此起始条件设定变压器原边电压激励，利用磁路-电路耦合有限元法建立了2D轴对称模型，计算了变压器原、副边线圈及各线匝短路电磁力。
• The transformer adopts multiple secondary compensation winding structure. The primary winding is in parallel with the harmonic load and the secondary compensation windings are connected with PWM inverters.
  变压器采用副方多补偿绕组结构，原方绕组与谐波负载相并联，副方补偿绕组分别与逆变器相联。
• Analysis of an Oil-Immersed Current Transformer Primary Winding Failure
  油浸式电流互感器一次绕组故障实例分析